Good to see you!
Otherwise login by email.
Welcome to Dulux
Otherwise login by email.
Terms & Conditions
Registration complete
Successfully registered, please login
Registration complete
Forgotten your password?
Please enter email address associated to your account
Change Password
Password changed successfully.
Request sent!
For more tailored inspiration, please fill in the 3 questions below.
You need to answer all of the questions before submitting.
Thanks!
We will send you colorful news every now and then

Diamond Glaze Satin
Your Measurements:
Amount Needed:
For the best result we recommend to use
{coatAmount} for {productTitle}
-
Finish Satin
-
Coverage 20m² per litre
-
Drying Time Touch Dry: 1-2 hours (faster on absorbent surfaces)
Recoat: 2-4 hours. Drying time will vary according to temperature and humidity and will take significantly longer in cold, damp conditions.
-
DIAMOND TOUGH
Product Description
Diamond Glaze Satin from Dulux is a water-based maximum durability interior clear wood varnish. It is a simple one pack system and is ideal for use on wooden floors and other high wear interior wood surfaces. It is up to ten times tougher than conventional varnish and is resistant to common chemicals, alcohol and water.
Application Description
STIR THOROUGHLY BEFORE USE, taking care not to use a whipping motion, which will introduce air and cause foaming when applied. Apply 2 or 3 coats of Diamond Glaze Varnish from Dulux Trade using either a brush or short pile mohair roller. Apply evenly and consistently, taking care to keep the 'wet edge' alive and finish off along the grain. Apply a small test area first to check adhesion and appearance. When recoating allow at least 2 hours between coats. Rub down lightly along the grain between coats using a fine grade adhesive paper.
Health & Safety
Please note that this item has additional safety or regulatory datasheets available. The product may have possible health and safety hazards covered in these documents. Refer to the container for full information and always follow the instructions.
Tips & Advice
-
1. Preparing the SurfacesTo get the best results, ensure surfaces to be varnished are sound, clean and dry. Special precautions should be taken during surface preparation of pre-1960s paint surfaces over wood and metal as they may contain harmful lead.
-
2. CleaningAfter use, remove as much product as possible from equipment before cleaning with water.
-
3. StoringDo not use or store in extremes of temperature and protect from frost. To prevent spillage, please store and transport upright.
How much paint do I need?
Measure the height and length of the surface you want to paint (in metres or centimetres).


Your Measurements:
{{!-- This value will be injected with JavaScript --}}
Amount needed:
{{!-- This value will be injected with JavaScript --}}
This is an estimated based on 2 coats. Actual coverage will depend on the conditions of the surface. If the colour change is strong, more coats may be required.