Dulux Easycare Satinwood
Our Dulux Easycare Satinwood is a water-based finish for interior wood and metal.
Our Dulux Easycare Satinwood is a water-based finish for interior wood and metal. Ten times tougher than conventional satinwood, it is water based, scuff-resistant and perfect for areas of high wear. It is also easy to spread, requires no undercoat and has a non-yellowing formulation. Available in a range of beautiful colours, ideal for doors, skirting and kitchen units.
Apply with a roller or brush.
To get the best results with Dulux Easycare Satinwood, make sure surfaces to be painted are sound, clean, dry (new surfaces particularly must be fully dry). Remove all loose and defective paint. Special precautions should be taken during surface preparation of pre-1960s paint surfaces over wood and metal as they may contain harmful lead. Where necessary, wash the surface to remove dirt, grease and powdery or dusty residues. Rinse with clean water and allow to dry. Seal surfaces that remain powdery after thorough preparation with an appropriate plaster sealer. Where necessary, rub down and then wipe off with a damp, lint free cloth to avoid dust.
After use, remove as much paint as possible from equipment before cleaning with water.
Do not use or store in extremes of temperature and protect from frost. To prevent spillage, please store and transport upright.
Enter the height and the length of the surface you want to paint.
Great! Just add it below and find out how much you'll need.
Measure the height and length of the surface you want to paint (metres).
This is an estimate based on 2 coats. Actual coverage will depend on the conditions of the surface. If the colour change is strong, more coats may be required.Calculate again